1. Manuals
  2. Consumer Electronics Support
  3. Brinkmann Support
  4. Gas Grill Support
Support User Manuals
Question About Brinkmann Gas Grill 4 Burner Gas Grill
How do I ignite flame...

How do I ignite flame

Asked by Pamela on 06/29/2014 2  Answers

ManualsOnline posted an answer 10 years, 5 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 5 months ago

5 The user manual is available for download here: http://images.brinkmann.net/docs/pdf/810-8411-5.pdf You should be able to light the main burners using the ignition burner control knob but if that doesn't work you can use the lighting hole. Page 10 and 11 describe the process. "LIGHTING THE MAIN BURNERS: 1. Open lid before lighting burner. 2. Make sure all control knobs are in the "OFF" position. 3. Push and hold down the IGNITION BURNER control knob and turn SLOWLY (2 to 3 seconds) to "IGNITE". You should hear the ignitor click. Note: Step 3 may need to be repeated 2-3 times to light grill. 4. If ignition does NOT occur in 5 seconds, turn control knob to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting procedure. 5. To light other burners, push and turn control knobs to HIGH in sequence from right to left. Follow Step 4. 6. If burner does not ignite using the igniter, wait 5 minutes, see "Match Lighting the Main Burners" section. 7. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the cylinder. MATCH LIGHTING THE MAIN BURNERS: 1. Open lid before lighting. 2. Turn the burner control knobs to "OFF". 3. Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to approximately 1/2" (1 to 2 cm) from the burner. 4. Turn on the FAR LEFT burner control knob to the "HIGH" position. The burner should light within 5 seconds. 5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure. Lighting Hole 6. To light other burners, push and turn control knobs to HIGH in sequence from right to left. Follow Step 5. 7. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual. 10 Matchlighter   Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill."
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual