1. Manuals
  2. Consumer Electronics Support
  3. Cobra Electronics Support
  4. Automobile Alarm Support
Support User Manuals
Question About Cobra Electronics Automobile Alarm None
changing battery in fob...

I have changed the battery in the fob and now nothing happens, i undone the drivers door with the key and alarm goes off, i have dicconected the battery on the car, what should ido now?

Asked by steve on 08/30/2008 1  Answer

ManualsOnline posted an answer 16 years, 3 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Marty posted an answer 15 years, 10 months ago

0 You probably need to reprogramming fob You'll need the override touch key and your alarm PIN. 1) Hold the two buttons on the alarm fob until the LED on the fob stays on 2) Turn the ignition on and off three times in a row ( don't start the engine, just so the dash lights show) The LED on the dash will come on then go off after about 3 seconds 3) Turn the ignition on - the LED will flash - you have to count the flashes - these correspond to the alarm PIN - when the LED has flashed the first number turn off the ignition. 4) Repeat step 3 for all four number of the pin. 5) Turn the ignition on ( the LED on the dash should be off ) and touch the override key in the override socket The LED will come on and stay on 6) Press the big button on the alarm fob Your fob should now be programmed. Good luck - if you muck up the counting of flashes, just wait ten seconds and start again - you won't ever block your alarm no matter how many times you give this a go.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual