1. Manuals
  2. Consumer Electronics Support
  3. Craftsman Support
  4. Edger Support
Support User Manuals
Question About Craftsman Edger None
craftsman edger 536.772210...

will not run on its own. cleaned carb, carb is getting gas, gas is new, will start on first pull if i spray with starter fluid. i think it is a problem with the linkage but a can't find any pictures on how the linkage should go.

Asked by mario on 05/02/2009 1  Answer

ManualsOnline posted an answer 15 years, 7 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

jon posted an answer 14 years, 3 months ago

0 Just went thru the same issue. Above the fuel bowl is a screw to cotrol fuel flow. Mine kept turning itself in while the engine was running, and would cut off the fuel flow. I removed the screw, added a drop of removeable threadlocker and reinstalled the screw. Once it bottoms out, back off 3/4 turn. Edger started and ran fine after that.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual