Need help in replacing pure source ultra water filter

Asked by Mary on 07/03/2014 1  Answer

ManualsOnline posted an answer 10 years, 5 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 Good Morning Marycurlin, I understand you need help replacing the pure source water filter in your Frigidaire refrigerator, model# FPHS2699KF1. To replace your PureSource UltraTM water filter: It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1) Turn Off the ice maker power switch. 2) Remove the filter by pushing on the end/face of the filter. 3) Slide the old water filter cartridge straight out of the housing and discard it. 4) Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing. 5) Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector). 6) Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. 7) After filling one glass of water, continue flushing the system for about three minutes. 8) Turn On the ice maker. 9) Press and hold the Filter Status button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “replace” to “Good,” the status has been reset. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful. -Best Regards-
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.