1. Manuals
  2. Consumer Electronics Support
  3. Genie Support
  4. Garage Door Opener Support
Support User Manuals
Question About Genie Garage Door Opener 1/2 HP 2060L-07
reset code...

How do I reset the code on my 2060L-07

Asked by Arletta on 02/01/2012 9  Answers

ManualsOnline posted an answer 12 years, 10 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Daniel Brockman posted an answer 12 years, 9 months ago

3 @arletta4 After much investigation this afternoon, I found the "learn" button on my device and successfully used it to reset the codes. We lost one of our remotes and feared it stolen. Here is what you do.... Open the white cover to reveal the light bulbs. You don't have to remove the cover completely. You can open it without special tools. Looking at the device from the garage door end, with the track over your right shoulder, look at the left edge of the device. Start at the bottom and run your eyes upward. You will see a D-shaped hole. Ignore it and keep going upward. You will see a tiny light that looks like a button. Keep moving your eyes upward. You will see a tiny button that looks like a light. That's the LEARN button. You will wish your finger was much smaller than it is. Push the learn button and hold it. The light will begin flashing. Continue holding it for about 10 seconds until the light goes out. You just reset the codes. Now reset the remotes (find instructions elsewhere). Close the cover. You are through.
Was this answer helpful?

Larry posted an answer 11 years, 3 months ago

2 that's the easy part - how do you re program for a new code?
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual