1. Manuals
  2. Consumer Electronics Support
  3. Holmes Support
  4. Humidifier Support
Support User Manuals
Question About Holmes Humidifier 1700
why humidifier puts out air but no water mist has ...

why humidifier puts out air but no water mist has new filter.

Asked by reva tucker on 05/05/2014 1  Answer

ManualsOnline posted an answer 10 years, 7 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 6 months ago

5 1. Turn off and unplug your Holmes humidifier. 2. Disassemble your humidifier. Remove the water tank. If your humidifier has a removable tray with filter, remove and set aside for later cleaning. 3. Remove water from the water tank and/or unit base. Uncap the water tank, set the cap aside and pour any water down your sink drain. Carry the base to your sink, and carefully pour out the water. 4. Put on your mask and gloves, and clean the tank/base. Fill the pieces with undiluted white vinegar or with Holmes Cleanse Clean. Soak 20 to 30 minutes, and wipe all interior surfaces with a microfiber cloth or soft-bristle brush to remove any mineral scale or other particles/debris. 5. Rinse the pieces. To rinse the tank, pour out the cleaner, refill with clean water, re-cap and shake. Uncap the tank, pour out the water, and rinse again under running tap water. To rinse the base, wipe the interior of the base including the heating element (warm mist models) with a dry microfiber cloth, and wipe with a warm, wet microfiber cloth. Set the base aside to air dry, and go to step 6 to disinfect the water tank. 6. Pour 1 gallon of water in the tank, and add 1 tsp. of bleach. Soak for 20 minutes. To rinse, follow the instructions in step 5 until you can't smell any bleach. Set the tank aside to air dry. When finished, go to the next section to clean the tray and filter and reassemble the unit. Tray and Filter 7. Fill your sink with 1 gallon of cool tap water and add 1 tsp. concentrated dish detergent. 8. Wash the tray and filter. Place the pieces in the water. Gently swish the filter around in the soapy water, and allow it and the tray to soak in the water for 15 to 20 minutes. Wipe the tray with a microfiber cloth and/or soft-bristle brush to dislodge any mineral scale or other particles/debris. Dislodge scale and particle/debris on the filter by swishing and dunking it in the water two to three times. 9. Rinse the pieces thoroughly under cold running tap water to remove soapy residue. 10. Remove excess water from the filter by pressing its surface gently and shaking it in an up and down motion over your sink.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual