1. Manuals
  2. Consumer Electronics Support
  3. Hoover Support
  4. Vacuum Cleaner Support
Support User Manuals
Question About Hoover Vacuum Cleaner None
Hoover Concept One Model U3305...

How do I change both drive belts. It looks like there are clamps on bottom of cleaner.

Asked by lmcgee1412 on 04/19/2009 1  Answer

ManualsOnline posted an answer 15 years, 7 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

tony posted an answer 15 years, 7 months ago

0 The clamps are the retention clips for the vacuum bottom. Pry off the clips and remove the black plastic cover. It may take quite a bit of wiggling to get the item off, but it will swing out from the front edge of the vacuum. Bot belts come off the same motor spindle. Drive belt first onto the spindle, then on the black wheel (when you turn the black wheel without the belt, the gray drive wheels should turn). The longer belt is the "agitator" belt and it goes on to the motor spindle and then around the brush. The brush should lift out of the housing allowing the belt to go around. You may also have to bend out the housing near the motor spindle to get the belts around it. After belts are on, the black cover goes back on. Make sure you first put the front of the housing on the front of the vacuum and then swing it down to fit. Put the clamps back near where they will clip and then force the middle of the clamp so that it snaps in. That should be it. Sorry, but I don't have a manual.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual