1. Manuals
  2. Consumer Electronics Support
  3. Kenwood Support
  4. Stereo Amplifier Support
Support User Manuals
Question About Kenwood Stereo Amplifier None
kenwood power amplifier help wiring it up....

I have the rca cable running from the deck to the amp and I have connected the battery to the terminal and the ground or as it is on the amp GND hooked up and I also have the remote wire hooked up. I also have it wired in the bridge for more power to run a subwoofer. But I am not getting any sound. At all. Help

Asked by oscar on 03/04/2009 1  Answer

ManualsOnline posted an answer 15 years, 9 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

mickey posted an answer 15 years, 6 months ago

0 have you checked your fuses?and is the amp powering on?also check to see if your stereo/mono selection switch is set to mono since you have it bridged
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual