1. Manuals
  2. Consumer Electronics Support
  3. Logitech Support
  4. Speaker System Support
Support User Manuals
Question About Logitech Speaker System None
need pinout for Logitech z4 speakers remote...

need pinout for Logitech z4 speakers remote control 9 pin as I lost the remote cable.

Asked by John on 04/01/2011 19  Answers

ManualsOnline posted an answer 13 years, 8 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Hector posted an answer 9 years, 8 months ago

9 What is the pin order in the DB9 female connector on the system?? Is it like this??
Was this answer helpful?

AllJunk posted an answer 10 years, 1 month ago

6 Logitech Z4 DB9 remote pinout scematic diagram 1 L OUT 2 L IN 3 S IN 4 ON 5 +5V 6 R OUT 7 R IN 8 GND 9 LED? To run the Z4 without a remote: Connect 4-5 Power Switch Connect 1-2 Route Left Channel Connect 6-7 Route Right Channel No Sub volume adjustement: Add 10k resistor from 1-3 Mix left channel to sub Add 10k resistor from 6-3 Mix right channel to sub Sub volume adjustment: Add 10k resistor from 1-Pot top Mix left channel to sub Add 10k resistor from 6-Pot top Mix right channel to sub Add wire from Pot center to pin 3 Add wire from 8- Pot bottom Uncertain what 9 is used for. Possible LED?
Was this answer helpful?

Simon posted an answer 9 years ago

0 good job
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual