plug it in it runs about a minute then reset pops out has fault code of E1 chart says cad cell shutdown?

Asked by roger on 01/03/2009 2  Answers

ManualsOnline posted an answer 15 years, 11 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 After about 1 minute of operation heater shutsdown and I receive an E1 cad shutdown code
Was this answer helpful?
0 clean the cad sensor it will look like a little clear eye. kind of like the eye on a outside light. the cad sensor looks for the light that the flame gives off so if it is dirty the unit don't know it there is a flame or not. you should just be able to wipe it off with a towel or somthing. it will be located somewhere near the flame. don't be sared to tear it a part, after whats the worst thing that could happen lol
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.