1. Manuals
  2. Consumer Electronics Support
  3. Panasonic Support
  4. Stereo System Support
Support User Manuals
Question About Panasonic Stereo System None
My surround speakers and my subwoofer are not wor...

My surround speakers and my subwoofer are not working my front ones are working I have check it All conection look good help lulu

Asked by Lulu on 06/24/2014 1  Answer

ManualsOnline posted an answer 10 years, 5 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 4 months ago

5 How to use your surround speakers and subwoofer effectively Turn off all equipment before connection. Do not connect the AC power supply cord until all other connections are complete. Be sure to match the number on each cable-sticker with the connector color. Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable. Press [SURROUND] several times to select the effect The selected effect will only be displayed on the main unit. 2 While “MANUAL” is displayed, press [2, 1] and select the desired effect. Adjusting speaker level during play Press and hold [–CH SELECT] to activate the speaker setting mode Press [–CH SELECT] several times to select the speaker Each time you press the button: L R—) C_) RS_)RB*_) LB*_)LS_) SW Press [3] (increase) or [4] (decrease) to adjust the speaker level for each speaker. Changing the sound modes Press [SOUND] several times to select the mode. The selected mode will only be displayed on the main unit. While the selected mode is displayed, Press [2, 1] and select the desired setting. The sound effects/modes may not be available or have no effect with some sources. You may experience a reduction in sound quality when these sound effects/modes are used with some sources. If this occurs, turn the sound effects/modes off. Check the 2CH STEREO You can play any source in stereo. Sound will be output to the front speakers and the sub-woofer only. * When the optional surround back speakers are connected. L R: Front speaker (left and right: only the balance is adjustable.) Press [2, 1] to adjust the balance of the front speakers C: Center speaker RS: Surround speaker (right) RB*: Surround back speaker (right) LB*: Surround back speaker (left) LS: Surround speaker (left) SW: Sub-woofer The channels not included in the playing audio will not be displayed (sub-woofer is displayed even if it is not included). The setting you make is retained, and recalled every time you play the same type of source. The setting you make is retained, and recalled every time you play from the same type of source.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual