1. Manuals
  2. Consumer Electronics Support
  3. Select Comfort Support
  4. Other Support
Support User Manuals
Question About Select Comfort ufcs2
E0 Code...

Try changing the 9volt battery. This worked for me. Once the battery is replaced, hold down both left UP and DOWN arrows. There will be a countdown. At the end of the countdown you should see C1. Let it display for 60 seconds or until it goes away. You should now see 00 or whatever the current pressure is. You may now adjust each side to your desire. Hope this helped.

Asked by Jon on 08/26/2009 6  Answers

ManualsOnline posted an answer 15 years, 2 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Larry posted an answer 9 years, 8 months ago

5 I replaced battery & held the left up & down arrows but never saw the C1, it just showed EO again. So I called their customer service number. They said I needed to unplug the electric pump, wait ar least 30 sec. then plug it back in. Once I did that the remove worked again. Customer service said that if your house looses power, this causes that problem sometimes (sure enough, a couple of weeks ago we lost power in the night). Hope this helps. Paul
Was this answer helpful?

Paul posted an answer 14 years, 8 months ago

5 I replaced battery & held the left up & down arrows but never saw the C1, it just showed EO again. So I called their customer service number. They said I needed to unplug the electric pump, wait ar least 30 sec. then plug it back in. Once I did that the remove worked again. Customer service said that if your house looses power, this causes that problem sometimes (sure enough, a couple of weeks ago we lost power in the night). Hope this helps. Paul
Was this answer helpful?

Lois posted an answer 13 years, 4 months ago

1 Well, if that doesn't work and you don't want to be spending a lot of money ...then....disconnect the air hose to the mattress compartment at the pump and, using a manual or electric pump you can buy at Walmart for filling air mattresses, insert into the air tube and pump in the amount of air you want. You Then reconnect the tube to your select comfort pump and you are good to go. Completely bypasses the remote and the possibly faulty pump. Fills up in a hurry !
Was this answer helpful?

Gene Hershberger posted an answer 15 years, 2 months ago

0 I tried the repalcing battery and holding down the up and down arrows. I still get the E0 code. Any suggestions?
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual