Installing the RAS 1500 System 2-3
Installing the RAS
1500 System
The RAS 1500 system consists of a router module (RM) and up to two
port expansion modules (PEMs). You can install RAS 1500 either as part
of a stack of equipment or in a standard 19-inch rack.
WARNING:
To avoid personal injury or damage to the unit, make sure
the stack or rack into which you install RAS 1500 is placed on a stable
surface.
Installing the
RAS 1500 System
in a Stack
Use the following steps to install both and RM and PEM in a stack:
1
Peel each rubber foot from the adhesive sheet and attach it to the
bottom of the unit. Use the circular marks on the bottom of the unit as
guides.
2
Place the unit into an existing stack of equipment, or on a smooth, level
surface.
Installing the
RAS 1500 System
in a Rack
Use the following steps to install both and RM and PEM into a standard
19-inch rack:
For rack installations, do not attach the rubber feet to the unit.
1
Fully extend the cable guides on the enclosed mounting brackets.
2
Fasten the mounting brackets to both sides of the RM or PEM using the
enclosed screws and a Phillips-head screwdriver.
3
Mount the modules in the rack.
Cover screw
Enclosed screws
