10
CPS – Cathodic Protection System–
120 Hz or 100 Hz (based on 60/50 Hz
selection)
Press the down key to enable/disable
the frequency. A check mark will
appear in the box when the frequency is
enabled.
50 Hz / 60 Hz
To change the power frequency
selection, press the up (60) or down
(50) key. The selected frequency will
appear in the box at the center of the
screen.
Snapshot/Continuous Depth Modes
Continuous depth measurements can
be displayed on the screen in live mode
or the depth can be frozen in snapshot
mode.
Press the down key to enable/disable
snapshot depth mode. A check mark
will appear in the box when snapshot is
enabled.
Depth Units
Select the up (inch) or down (cm) key
to select the preferred units of measure.
The selection will appear in the box at
the center of the screen.
Information
This screen provides important
information including the product serial
number, as well as the software and
hardware versions of the unit.
