A SERVICE OF

logo

Chapter 3 61
Removing the LCD Module/the Power Board and the Keyboard
Removing the LCD Module
1. Remove the two (one on each side) screws holding the LCD antenna covers.
2. Then take away the antenna cover.
3. Open the LCD to an angle of 95 degree from the main unit. Then remove the strip cover (middle cover).
4. Turn out the two screws on the rear panel.One on each side.
5. Then remove the two screws on the button panel. One on the left and the other on the right.
6. Remove the screw that secure the EMI bar. Then remove the EMI bar.
7. Disconnect the coaxial cable connector.
8. Then, you can remove the entire LCD module.
Removing the Power Board and the Keyboard
1. Remove the two screws holding the power board.Then remove the power board.
2. Turn out the two (one on each side) screws that secure the keyboard.
3. Disconnect the keyboard FFC. After disconnect the keyboard connector then remove the keyboard.