Agri-Fab 45-0381 Manual

next previous

10. Secure the axles to axle support brackets using two

washers (K) and 1/8" x 1-1/2" cotter pins (L) at the ends

ofeachaxle.Seegure7.

11. Tighten the four axle brackets assembled in step 10.

Seegure7.

12. Add grease to the spool assemblies through the grease

ttingsuntilgreaseisforcedouttheendsofthespool

tubes.Seegure7.

GREASE

FITTING

WEIGHT

BRACKET

STRAP

MAST

EXTENSION

STRAP

MAST

SIDE

AXLE

SUPPORT

BRACKETS

4. Attach the weight bracket to the tray using a 3/8" x 1"

bolt (H) and 3/8" nylock nut (I). Do not tighten yet. See

gure4.

5. Assemble the straps to the holes in the weight bracket

and the tray that are aligned. Use two 1/2" x 2-1/4" bolts

(B), .75" spacers (O) and 1/2" nylock nuts (J). Do not

tighten yet.Seegure4.

6. Attach the mast extension straps to the front of the tray

using two 1/2" x 1-1/4" bolts (C) and 1/2" nylock nuts

(J). Do not tighten yet.Seegure5.

7. Assemble the mast sides to the straps using the 1-1/2"

spacer (P), 1/2" x 3-1/2" hex bolt (A) and 1/2" nylock

nut (J). Do not tighten yet.Seegure5.

8. Tighten all loose nuts assembled through step 7.

9. Attach the four axle support brackets to the tray using

eight 3/8" x 1" hex bolts (H) and 3/8" nylock nuts (I). Do

not tighten yet!Seegure6.