Operation
13
F232227
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operating Instructions
1. When display shows “Cyxx,” washer-extractor is
ready to be loaded with laundry.
2. Use left hand to press and hold the door unlock
button located on the lower right front of the
control panel. Refer to Figure 3.
Figure 3
3. Use right hand to turn door handle clockwise and
swing the door left to open. Refer to Figure 4.
Figure 4
4. Load the washer-extractor to full capacity
whenever possible, but do not exceed the rated
dry-weight capacity of the machine if the fabric
to be washed is quite dense, closely woven, and
heavily soiled.
Overloading can result in an inferior wash. The
operator may need to experiment to determine
load size based on fabric content, soil content,
and level of cleanliness required. Do not
underload the machine. Underloading can result
in premature bearing and sealing failure and out-
of-balance situations.
Figure 5
PHM626N
PHM593N
<
<
12
3
4
5
6
PHM590N
WARNING
MACHINE MAY B
E HOT
AND CAUSE BUR
N
S
ATTEMPT NO ENTRY UNTIL
BASKET HAS STOPPED
SERIOUS INJURY
MAY
RESULT
Do not operate machine in a cycle with
program keymode switch in program
position. Program keymode switch must
be in run position at all times, except
when editing or programming cycle or
setup information.
W528
WARNING
Do not operate machine in a cycle or if
spinning with program keymode switch in
program position.
W529
WARNING
