ATEN Technology CS-82A / CS-84A Manual

A SERVICE OF

next previous

- 14 -

Setting the CS-82A’s Scan Interval

The default amount of time that the CS-82A dwells on each port

is five seconds. You can change the scan interval at any time

while Auto Scan is in effect by keying in a number from 1 to 4 that

corresponds to the following scan intervals:

Once scanning begins, it continues until you press the

[Spacebar] to exit Auto Scan Mode. The port that has the KVM

focus at the time scanning stops remains active.

Note: While Auto Scan Mode is in effect, the console will not

function normally. You must exit Auto Scan Mode by

pressing the [Spacebar] in order to regain control of the

console.

Number Scan Interval

1 3 seconds

2 5 seconds (default)

3 10 seconds

4 20 seconds