Installing the Control Unit
Step 2a: Installing the Feature Module
This procedure is part of a larger procedure for installing the processor. If
you have not already read the beginning of this section, “Installing the
Processor,” do so before continuing.
Upgrades: If you are upgrading an existing system, skip to
“Step 2b: Replacing the Feature Module.”
Before you install the processor in the carrier, you must install the feature
module in the processor:
a.
b.
c.
d.
e.
Unpack the feature module.
Fasten the round feature module label to the front of the processor
housing.
Put the processor on a flat surface as shown in Figure 2-13.
Align the connectors on the feature module with the connectors in the
processor as shown in Figure 2-13.
When you are sure that the feature module is properly seated, press it
firmly into place.
Installing the Processor
2-43
