Operation
42
Select the lamp saver mode
• Using the remote control.
Press Smart Eco and Highlight Lamp Mode and press / to select Normal/
Economic/Smart Eco.
•Using the OSD menu.
1. Press MENU/EXIT and then press /
until the SYSTEM SETUP: Advanced menu
is highlighted.
2. Press to highlight Lamp Mode and press
MODE/ENTER. The Lamp Settings page
displays.
3. Highlight Lamp Mode and press / to
select Normal/Economic/Smart Eco. The lamp brightness vary from the
different lamp mode,see the description list in table below.
•
If the Economic mode is selected, the light output will be reduced and result in darker
projected pictures.
Use build-in test pattern
You can adjust the image shape and focus status by observing
the input signal content, or using the test pattern build-in
OSD manual from OSD for better observe the shape
changed.
Open the OSD menu and go to the SYSTEM SETUP:
Advanced > Test Pattern > On. Press MODE/ENTER.
The Test Pattern displays.
Lamp Mode Description
Normal 100% lamp brightness.
Economic 80% lamp power consumption.
Smart Eco
This is default setting. Lamp power consumption will save from 30% to
100% dynamically by detecting the content brightness level.
