Operation 43
Function Description
Standby
Settings
Network
Selecting On enables the function. The projector is able to provide the
network function when it is in standby mode.
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER 1 jack is
correctly connected to devices. See "Connection" on page 16 for how
to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. When you select Computer
1 or Computer 2, audio signal can only be fed into the AUDIO-IN 1
or AUDIO-IN 2 jack. When you select Video,S-Video, audio signal
can only be fed into the AUDIO-IN L/R jacks. There is no need to
connect the audio cable when HDMI is selected since the HDMI cable
carries audio signal.
See "Connection" on page 16 for how to make the connection.
Enabling this function slightly increases the standby power consumption.
Network
Settings
Wired LAN
See BenQ Network Projector Operation Guide for details.
AMX Device Discovery
Selecting On enables the function. When AMX Device Discovery is
On, the projector can be detected by AMX controller.
Mac Address
Displays the mac adress of this projector.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Phase, H. Size, User 1, User 2,
Color Space Conversion, Projector Position, High Altitude Mode,
Security Settings, Network Settings and Baud Rate.
5. SYSTEM SETUP: Advanced menu
