A SERVICE OF

logo

APPENDIX B: AUDIO/SERIAL PORTS
39
4. Place the jumper across the posts as shown in Figure 11.
5. Set the hardware flow control jumpers to RTS/CTS Flow Control Across CATx Link as
shown in Figure 12. This mode will support most, but not all, serial mouse and trackball
devices.
You must also configure the Remote Unit to use this protocol. Refer to the manual
supplied with your Remote Unit.
Figure 10 Position of Baud Rate and Flow Control jumper blocks on
Serial Daughter Board
Baud Rate: 9600/19200 1200
(as set in
Remote Unit)
Figure 11 Baud Rate Jumper Settings in Local Hub (see Figure 10 for
location of jumper block)
Flow Control
Baud Rate