OPERATION
1. Place the base of the unit on a firm, flat, level and water-resistant surface.
2. Fill the WATER TANK according to the instructions on the next page and
place it on the humidifier base.
3. Plug the power cord firmly and completely into the wall outlet.
4. Push POWER/MODE switch to either the HI or LO position. Push SET HUMIDITY
button until desired humidity appears in the SET HUMIDITY
window of the digital display. The humidity can be set in 5% increments between
30 and 90% relative humidity. Desired humidity is normally set at 50% or below to
avoid over-humidification. The humidifier will produce vapor until the relative humidity
(indicated in the HUMIDITY window of digital display) reaches the SET HUMIDITY
setting. It will be normal for the humidifier to take 2 minutes to warm
up and begin to mist.
5. When the WATER TANK is empty (after approximately 24 hours running time),
the REFILL WHEN LIT light will go on, and the unit will stop heating.
Refer to the FILLING THE WATER TANK section on the next page.
6. Whenever the water falls below the level of the FLOAT during operation,
the heating element will shut off and stop heating.
7. MIST OUTPUT GRILLE may be adjusted manually by pointing in desired direction.
IMPORTANT: NEVER point the MIST OUTLET GRILLE at a wall.
8. For nighttime or other times when quieter operation is desired, push the POWER/
MODE switch until LO appears in the MODE window of digital display.
636126_INS0210_GermFreeHumidifier_5”Wx4.75”H_Output:100%_Prints:1/1,Blk
10
