SECTION IV
ASSEMBLY
20
MOUNTING SEAT
Remove either the standard seat, standard seat
w/armrests or the suspension seat from the card-
board container. Align the four 5/16” holes in the
seat frame with the four slots in the seat mounting
plate. Attach the seat using the hardware in the
parts bag accordingly (4 - 5/16” - 18 x 3/4” screws, 4
- 5/16” flatwashers, and 4 - 5/16” split lock washers
for the standard seats and the 5/16” - 18 nuts (4) for
the full suspension seat).
MOUNTING THE CONTROL
LEVERS
Remove the lower 3/8 x 1-1/4” fasten-
ers from the lower control lever mounting holes.
Move the control levers into place so both levers are
in line with each other and secure with 3/8 x 1-1/4”
bolt and lockwasher.
Control Levers
Seat Mounting
Plate
Slotted Hole
BATTERY
Attach the positive lead to the battery.
Additional wire tie straps are shipped to secure the
wiring harness as needed.
DISCHARGE CHUTE
The discharge chute for the 52” deck is shipped
separate from the deck. Place the chute into position
and fasten with the fasteners provided
ITEMS TO CHECK:
Check oil level in the engine (see engine manual)
Check tightness of all fasteners, including bolts, lug
nuts, and setscrews.
Check tire pressure.
Battery
CONTROL LEVERS
Fold control levers forward into position and fasten
into place as shown below using fasteners provid-
ed. Slotted hole at bottom of bracket allows position
adjustment of the levers.
Pivot Bolt
(3/8 x 1-1/2” w/Locknut)
Slotted Hole and Adjusting Bolt
(3/8 x 1-1/2” w/Flatwasher and Locknut)
Discharge Chute
