1. MAINTENANCE
1-1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and
Replacement Consumables by Service Engineer
(1) Adjustment
Note: DO NOT loosen the red screws at both ends of the carriage shaft, securing the print head position, as they are
not re-adjustable.
*1: Only for CD / DVD printing supported regions.
*2: The red screws securing the paper feed motor may be loosened only at replacement of the paper feed motor unit.
(2) Periodic maintenance
No periodic maintenance is necessary.
(3) Periodic replacement parts
There are no parts in this printer that require periodic replacement by a service engineer.
4
Re
lacement consumables
Adjustment Timing Purpose Tool
Approx.
time
EEPROM
initialization
(EEPROM
settings)
At logic board ass'y replacement To initialize settings other than
the following:
- USB serial number
- Destination setting
- Waste ink counter
- CD / DVD correction value
None. 1 min.
Destination
settings
(EEPROM
settings)
At logic board ass'y replacement
To set the destination.
None.
Perform in the
service mode.
1 min.
LCD language
settings
At logic board ass'y replacement To set the language to be
displayed on the LCD.
None. 1 min.
Waste ink
counter
resetting
(EEPROM
settings)
- At logic board replacement
- At waste ink absorber
replacement
To reset the waste ink counter.
None.
Perform in the
service mode.
1 min.
CD / DVD
detection sensor
light volume
correction
*1
- At logic board replacement
- At carriage unit replacement
To correct the light volume for
the CD / DVD detection sensor.
None.
(Automatically
performed in the
service test print)
2 min.
Ink system
function check
- At logic board replacement
- At platen unit replacement
- At carriage unit replacement
To maintain detection
functionality for presence of the
ink tanks and each ink tank
position.
None.
Perform in the
service mode.
1 min.
Paper feed
motor position
adjustment
*2
At paper feed motor
replacement
To adjust the belt tension.
(Position the paper feed motor so
that the belt is stretched tight.)
None.
5 min.
Grease
application
- At carriage unit replacement
- At PR shaft ass'y replacement
- At CL base or CL gear
replacement
- To maintain sliding properties
of the carriage shaft and the lift
cam shaft.
- To protect the printer's sliding
portions (gears).
- FLOIL KG-
107A (QY9-
0057)
1 min.
