SKU 91020 PAGE 6
FIGURE A
FILLER
PLUG
(45)
RELEASE
VALVE
(47)
GREASE
FITTING
(33)
HANDLE
(36)
HEX CAP
SCREW
(44)
HANDLE SOCKET
(46)
not
to be working properly, it may be necessary to
purge
its hydraulic system
of excess air. To do so, remove the Filler Plug (45). Turn the Release Valve (47)
counterclockwise
to its open position. Pump the Handle rapidly numerous times.
The trapped air is pressurized and will be audible when released in this manner.
Once purged of air, check the Oil Chamber and, if necessary, top off the Oil Chamber
with hydraulic oil. Then replace the Filler Plug, and turn the Release Valve
clockwise
to its closed position. Pump the Handle several times, using full, smooth strokes.
The Transmission Jack should now operate properly. If, after purging, the Hydraulic
Jack still does
not
appear to be working properly, do not use the Hydraulic
Jack until it has been repaired by a qualified technician. (See Figure A.)
To Lower A Transmission Onto The Transmission Jack:
1. IMPORTANT! When raising a vehicle, make sure to use a commercial grade lift or
jack fully capable of supporting the weight of the vehicle. Also, read and understand
all safety warnings and precautions as outlined in the manufacturer’s manual for the
lift or jack.
RELEASE
CHECK VALVE
BYPASS VALVE
(DO NOT ADJUST)
