Q-Wash 250 User Manual 10 2006-05-17/13:18
Terminator
sold separately
Operating Modes
A stand-alone mode will listen to sound and run through its diverse range of built in programs.
Master/Slave mode will allow the command of up to as many units you want in a synchronized
light show to the sound.
DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be
controlled individually using any universal DMX-512 controller.
Master/Stand Alone
Two options are available, a sound-active mode or an automatic mode. In sound-active mode the
internal programs are triggered by the beat of the sound. In automatic mode the internal programs run
at the chase time pre-recorded. It is your choice to enable each fixture to run in Stand Alone mode by
activating either of the two functions below or to proceed to enable slave fixtures as described in the
following section.
MENU SET TO NOTES
RUN
Pr6.1
Sou.1
Pr6.2
Sou.2
Auto 1 (use when fixture is flown and hangs upside down)
Music 1 (use when fixture is flown and hangs upside down)
Auto 2 (use when fixture is floor positioned)
Music 2 (use when fixture is floor positioned)
Setting Slave Fixtures
The Master/Slave mode will allow you to link multiple units in a daisy chain fashion. In this mode, the
first unit in the daisy chain, the master, will automatically command all other units following. The first
unit will operate in a Stand/Alone mode and all units following will synchronize to the first unit.
MENU SET TO NOTES
RUN SLAE Slave mode
You can Invert the Pan and Tilt settings freely.
DMX Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to
customizing or creating a show. You can tailor your programming to suit a specific event. Whether it
is a wedding where a spot light may be required or a lead singer requiring a color solo, the
opportunities are endless. In this mode you will be able to control each individual trait of the fixture
independently.
MENU SET TO NOTES
RUN dn.Co.
DMX-512 mode
Daisy Chain Connection
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
