A SERVICE OF

logo

EN STRIKE 324 QRG
3
Replacing the
Fuse
1. Disconnect this product from power.
2. Using a Flat head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type
and rating.
4. Screw the fuse holder cap back in place and reconnect power.
DMX Linking
The STRIKE 324 will work with a DMX controller using a regular DMX serial
connection. A DMX Primer is available from www.chauvetpro.com.
DMX Connection
The STRIKE 324 uses a regular DMX data connection for its DMX
personalities: 1 Ch, 5 Ch, 8 Ch, and 12 Ch
. See the User Manual to connect
and configure for DMX operation.
Master/Slave
Connection
The STRIKE 324 uses the DMX data connection for its Master/Slave mode.
See the User Manual to connect and configure for master/slave operation.
Mounting
Product
Mounting
Diagram
Secure the safety cable using
the passageway on the back
of the product.
Overhead Mounting
Floor Mounting
Clamp
(Model #CLP-15)
Safety Cable
(Model #CH-
05)