LED Par 64-36VW B&C User Manual 11 Rev. 4
Custom Static Color Mixing
This fixture has the ability to accept custom static color settings. These are accessed via the control panel.
Please see the instructions below for further explanation.
1. Press <MENU> until
U-- appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired color value (
000~100). By selecting 000, the color
will remain off.
4. Press <ENTER> to continue to the next color (
r, C).
5. Using <UP> and <DOWN>, select the desired color value (
000~100). By selecting 000, the color
will remain off.
6. Continue until the desired mix is obtained.
7. Press <ENTER> to save the final color setting. This will move the selection to the following color.
However, this is necessary to save the modification.
The colors are represented by the following in the menu map:
r--- = Warm White (000~100)
C--- = Cool White (000~100)
DMX Channel Values
4-CH
1
Master Dimmer
Dimmer: 0%~100%
2
Warm White (2900K)
Dimmer: 0%~100%
3
Cool White (6300K)
Dimmer: 0%~100%
4
000 ó 015
No function
2-CH
1
Warm White (2900K)
Dimmer: 0%~100%
2
Cool White (6300K)
Dimmer: 0%~100%
Setting the Starting Address
This DMX mode enables the use of a universal DMX controller device. Each fixture requires a start address
from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that uses six DMX channels and was addressed to start
on DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start
addresses so that the channels used do not overlap, and note the start address selected for future reference.
