Appendix
CH-175 User Manual 10 2004-09-20/13:36
General Troubleshooting
Applies to
Symptom Solution(s)
Lights
Foggers
& Snow
Controllers
Dimmers
& Chaser
Auto shut off Check fan thermal switch reset
9
Beam is very dim or not
bright
Clean optical system or replace lamp
Check 220/110v switch for proper setting
9
Breaker/Fuse keeps
blowing
Check total load placed on device
9
Chase is too slow Check users manual for speed adjustment
9
9 9
Device has no power Check for power on Mains.
Check device’s fuse. (internal and/or external)
9
9 9
Lamps cuts off
sporadically
Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
9
Motor movements are
jerky or jumpy
Possible bad motor driver or sensors
Check polarity switch on controller
9
9
Moves slow Check 220/110v switch for proper setting
9
No flash Re-install bulb, may have shifted in shipping
9
No light output Check slip ring & brushes for contact
Install bulb
Call service technician
9
Relay will not work Check reset switch
Check cable connections
9
Remote does not work Make sure connector is firmly connected to device
9 9
Unit wobbles when
rotating
Check for damages possibly incurred during shipping
9
