BOB™ LED User Manual 5 2/6/2012 2:49 PM
inside this compartment.
Remove using a Phillips
Fuse Replacement
With a Phillips #2 screwdriver, unscrew the fuse holder from its housing. Remove the damaged fuse
from its holder and replace with exact same type fuse. Screw the fuse holder back in its place and
reconnect power.
3. SETUP
Mounting
Orientation
This fixture may be used with the chain suspensions or with the 3X floor standing feet that are
provided with the fixture.
General Troubleshooting
Symptom Solution(s)
Lights
& Snow Controllers
& Chaser
Breaker/Fuse keeps
blowing
Check total load placed on device
ü
Check users manual for speed adjustment
Check for power on Mains.
Check device’s fuse. (internal and/or external)
If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support.
Contact Us
World Wide
General Information CHAUVET
5200 NW 108th Avenue
Sunrise, FL 33351
voice: 954.929.1115
fax: 954.929.5560
toll free: 800.762.1084
Technical Support CHAUVET
5200 NW 108th Avenue
Sunrise, FL 33351
voice: 954.929.1115 (Press 4)
fax: 954.929.5560 (Attention: Service)
World Wide Web www.chauvetlighting.com
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
