19-10
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 19 Configuring Flex Links and MAC Address-Table Move Update
Configuring MAC Address-Table Move Update
Configuring MAC Address-Table Move Update
These sections contain this configuration information:
• Default Configuration, page 19-5
• Configuration Guidelines, page 19-6
• Configuring MAC Address-Table Move Update, page 19-10
Default Configuration
By default, the MAC address-table move update feature is disabled.
Configuration Guidelines
Follow these guidelines to configure the MAC address-table move update feature:
• Enable mac address-table move transmit on the switch with Flex Links configured to send MAC
address-table move updates.
• Enable mac address-table move receive on all upstream switches to process MAC address-table
move updates.
Configuring the MAC Address-Table Move Update Feature
This section describes the following tasks:
• Configuring a Switch to Send MAC Address-Table Move Updates, page 19-10
• Configuring a Switch to Receive MAC Address-Table Move Updates, page 19-12
Configuring a Switch to Send MAC Address-Table Move Updates
To configure an access switch to send MAC address-table move updates, perform this task:
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(conf)# interface interface-id
Specifies the interface, and enters interface configuration
mode. The interface might be a physical Layer 2 interface
or a port channel (logical interface). The port channel
range is 1 to 64.
