Configuring Token Ring Inter-Switch Link
TRISL Configuration Examples
BC-157
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
IP Routing Source-Route Frames Between a TRISL VLAN and an Ethernet ISL
VLAN Example
Figure 57 illustrates IP routing source-route frames between a TRISL VLAN and an Ethernet ISL
VLAN.
Figure 57 IP Routing Source-Routed Frames Between a TRISL VLAN and an Ethernet ISL VLAN
The following is the configuration for the router:
interface fastethernet4/0.1
ip address 5.5.5.1 255.255.255.0
encapsulation tr-isl trbrf-vlan 999 bridge-num 14
multiring trcrf-vlan 200 ring 100
multiring all
!
interface fastethernet4/0.2
ip address 4.4.4.1 255.255.255.0
encapsulation isl 12
The following is the configuration for the Catalyst 5000 switch with the Ethernet module in slot 2 and a
Token Ring switch module in slot 5. In this configuration, the Token Ring port is assigned with TrCRF
VLAN 100 and the Ethernet port is assigned with VLAN 12.
#vtp
set vtp domain trisl
set vtp mode server
set vtp v2 enable
#drip
set tokenring reduction enable
set tokenring distrib-crf disable
#vlans
set vlan 999 name trbrf type trbrf bridge 0xe stp ibm
set vlan 100 name trcrf100 type trcrf parent 999 ring 0x1 mode srb
set vlan 200 name trcrf200 type trcrf parent 999 ring 0x64 mode srb
set vlan 12 name eisl12 type ethernet
#add token port to trcrf 100
set vlan 100 5/1
#add ethernet
set vlan 12 2/1
set trunk 1/2 on
5500
End statio
End statio
Ethernet ISL VLAN 12
5.5.5.1
4.4.4.1
TrBRF 999/Bridge 14
Router A
1884
Token Ring
switch module
in slot 5
TrCRF100
Slot 5
Ethernet
module
in slot 2
Catalyst
5000 switch
Token
Ring
1
100
rCRF 200
