Page 14 Coby Electronics Corporation
www.cobyusa.com Page 15
Connections
Connecting to an Amplier or Receiver
Connect one end of the RCA audio cable (white and
red) to the Audio Out jacks (L and R) located on the
rear of the HDR-650.
Connect the other end of the cable to the Audio
Line-In jacks of an amplier or receiver (white, red).
Set the amplier/receiver to the source input that
corresponds with the Audio Line-In jacks. Refer to
the documentation that comes with your amplier/re-
ceiver for more information.
For optimal volume control and audio delity, set the
volume level of the HDR-650 to approximately 80%,
and then adjust the volume to the desired level with the
controls of your amplier/receiver.
AM Antenna
The unit comes with an AM loop antenna designed
specically to receive AM signals.
Plug the AM loop antenna into the AM Antenna Input
port located on the rear of the unit.
Position and orient the antenna well away from the
unit for best reception.
1.
2.
3.
1.
2.
Getting Started
