A SERVICE OF

logo

Open as PDF
next previous
9
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged. Contact
De’Longhi Customer Services.
Installing the appliance
Important!
When you install the appliance, you should respect the
following safety warnings:
• The appliance gives o heat. After positioning the
appliance on the worktop, leave a space of at least 3 cm
between the surfaces of the appliance and the side and
rear walls and at least 15 cm above the coee maker.
• Waterpenetratingtheappliancecouldcausedamage.Do
not place the appliance near taps or sinks.
• Theappliancecouldbedamagedifthewateritcontains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrangethepowercableinsuchawaythatitcannotbe
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note :
• Coeehasbeenusedtofactorytesttheapplianceanditis
therefore completely normal for there to be traces of coee
in the grinder. The machine is, however, guaranteed to be
new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” on page 16.
1. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g. 1).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds).
2. When “English” appears, press the OK button (g. 2) for a
few seconds until “ENGLISH set” is displayed.
Follow the instructions indicated by the appliance:
3. “FILLTANK”:removethewatertank,lltotheMAXline
with fresh water then replace in the appliance (g. 3).
4. Turn the cappuccino maker outwards and place a container
with a minimum capacity of 100 ml underneath (g. 4).
5. “TURNSTEAMKNOB”isdisplayed.Whenthesteamknob
isturnedtotheIposition(g.4),“HotwaterPressOK”is
displayed.
6. Press the OK button (g. 2).
“Please wait” is displayed and the appliance begins to
deliver water from the hot water spout.
The appliance ends the rst start up procedure, then the
message “Turning o, Please wait” is displayed and the
appliance goes o.
The coee maker is now ready for normal use.
Please note:
• Whenusingtheapplianceforthersttime,youneedto
make 4-5 cups of coee or 4-5 cappuccinos before the
appliance starts to give satisfactory re-sults.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the I position (g. 1).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
• Toturntheapplianceon,pressthe button (g. 5).
The message “Heating up, Please wait” is displayed.
After heating, the message “Rinsing” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coee appears.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.