29
REPLACING THE OVEN LIGHTS
WARNING: Ensure the appliance is switched off before replacing the lamp/s to avoid
the possibility of electric shock.
■ Let the oven cavity and the heating elements to cool down.
■ Switch off the electrical supply.
LEFT LAMP
■ Remove the left wire rack and the side catalytic panel by unscrewing the xing screws
(see chapter “USE AND CARE” at page 14).
■ Press down from the top the protective cover “A” (g. 18) and remove it by rotating on
the lower side.
IMPORTANT: Never use screwdrivers or other utensils to remove the cover “A”.
This could damage the enamel of the oven or the lampholder. Operate only by hands.
■ Replace the halogen lamp “B” with a new one suitable for high temperatures having
the following specications: 220-240V or 230-240V, 50 Hz and same power (check
watt power as stamped in the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never replace the lamp with bare hands; contamination
from your ngers can cause premature failure. Always use a clean cloth or gloves.
■ Ret the protective cover “A” operating in reverse order.
ATTENTION: The notch in the inner edge of the cover must be oriented toward the
lamp. Assemble the side catalytic panel and the left wire rack.
TOP RIGHT LAMP:
■ Remove the protective cover “C” (g. 18).
■ Replace the halogen lamp “B” with a new one suitable
for high temperatures having the following specica-
tions: 220-240V or 230-240V, 50 Hz and same power
(check watt power as stamped in the bulb itself) of the
replaced lamp.
IMPORTANT WARNING: Never replace the lamp
with bare hands; contamination from your ngers
can cause premature failure. Always use a clean
cloth or gloves.
■ Ret the protective cover “C”.
NOTE: Oven bulb replacement is not covered by your gua-
rantee.
A
B
B
C
1
2
A
A
Figure 18
