CHLORINE FILTER (if fitted)
The filter eliminates the taste of chlorine from the water.To install
the filter, proceed as follows :
• Remove the chlorine filter from the plastic bag and rinse it in
tap water.
• Lift the coffee lid, remove the filter holder from its housing by
lifting it upwards (Fig. 1).
• Open the filter holder by pressing the parts marked “PUSH”,
and carefully position the filter as shown in Fig. 2.
•Close the filter holder and replace it in its housing, pushing it
fully down.
• The chlorine filter must be replaced every 80 cycles, and always
after six months of operation.
HOW TO PREPARE THE DRIP COFFEE
• Lift the cap and remove the water tank (Fig. 3).
• Fill the tank with fresh, clean water up to the level correspon-
ding to the number of cups of coffee required (Fig. 4).
• Place the tank back in the coffee maker, pressing it lightly.The
tank may also be filled without being removed, using the jug
marked with the level indicators (Fig. 5).
• Open the filter holder door by turning it to the left (Fig. 6).
•In versions with a permanent filter, place the filter in the filter
holder (Fig. 7). In other versions, use the #4 paper filter.
ig. 1
ig. 2
ig. 3
ig. 4
ig. 5 fig. 6 fig. 7
Coffee Maker EC190/200
