18
© 2006 Directed Electronics
Many Nissan and late-model Chrysler vehicles have two starter
wires. A relay and/or resistor (not provided) is required to hook up
the additional starter wire. Refer to the diagram below.
Once you locate the starter wire, cut the wire in half (check the
web information before cutting) and try to start the vehicle. If
the vehicle does not start, the correct wire has been identified.
Reconnect both ends of the starter wire while soldering the thick
YELLOW (6) wire of the heavy guage wires to it and wrap the
connection with electrical tape.
note! Always check the Web site information
on your vehicle for warnings regarding the
starter wire and check engine lights. Some
vehicles will trip a check engine light if the
starter wire is cut.
