A SERVICE OF

logo

SERIAL Digital I/O Series User Manual Eagle Technology - Data Acquisition
C
C.Troubleshooting
SRL Device Unavailable
Make sure that the Serial Number is corresponding with the Serial Number on the
device.
Check that cable is in the correct serial port.
Check that your Baud Rate is setup correct, default baud rate is 9600 baud.
If the baud rate have been changed, the new baud rate can be checked by using
HyperTerminal.
Disconnect the power to the device.
When running HyperTerminal, create a New Connection and set the baud rate to
9600. See picture below.
Select OK
Reconnect the power to the device. It should display the serial number and also the
baud rate at witch the device is going to run at. See picture below.
Eagle Technology © Copyright 2003 – www.eagledaq.com 40