Figure 17.Verify ConfigurationSettings
Figure 18.Verify ConfigurationSettings
Figure 19.Verify ConfigurationSettings
Figure 20.Clear CommunicationMessage
EATON Powerware
®
ConnectUPSt Web/SNMP Card (X and BD Models) Quick StartInstructions 164950185 Rev A 7
10. Select your preferred method of shutting down your system
(see Figure 17). The default selection is recommended.
Select
Next.
11. The Event and Logging Options dialog opens (see Figure 18).
Select
Next.
12. Verify the configuration settings are correct and select Finish
(see Figure 19).
13. A pop-up message indicates that communication with the
card is established (see Figure 20). Select
Clear to
acknowledge the message.
14. Repeat Steps 1 through 13 on all computers powered by the
corresponding UPS using this specific card.
NetWatch installation and configuration is now complete.
PowerwareandPowerVisionare registeredtrademarksandLanSafe, ConnectUPS,X-Slot,BestDock,and
CoreLogicaretrademarks ofEatonPowerQuality Corporation.Microsoft andWindowsareregistered
trademarksof Microsoft Corporation.HyperTerminal is aregisteredtrademarkofHilgraeve.Modbus isa
registeredtrademarkof Modicon.IBMandAS/400 areregisteredtrademarksofInternationalBusiness
Machines,Inc.
