NodeBuilder Errors Guide 6-3
NEX# Description
13 Unexpected EOF in file '<file>' at line #<line> [NEX#13]
Unexpected end of file. See error message for details. Attempt fix-
up with rebuild and contact LonSupport if problem persists.
14 Line # <line> in input file '<file>' is too long [NEX#14]
A record in an input file was longer than expected. See error
message for details. Attempt fix-up with rebuild and contact
LonSupport if problem persists.
15 Line # <line> in input file '<file>' is invalid [NEX#15]
A record in an input file is invalid. See error message for details.
Attempt fix-up with rebuild and contact LonSupport if problem
persists.
16
Line # <line> in input file '<file>', byte count is invalid
[NEX#16]
A record in an input file is invalid due to an incorrect byte count.
See error message for details. Attempt fix-up with rebuild and
contact LonSupport if problem persists.
17
Line # <line> in input file '<file>', checksum is invalid
[NEX#17]
A record in an input file is invalid, bad checksum. See error
message for details. Attempt fix-up with rebuild and contact
LonSupport if problem persists.
18
System image symbol table '<file>' is invalid: symbol
'<symbol>' not defined [NEX#18]
Missing a required symbol from the system image's symbol table.
See error message for details. Does the chosen system image
support the desired memory configuration? Change the firmware
version and image file to the default and perform an unconditional
build. Contact LonSupport if problem persists.
19
Specified transceiver type has invalid clock/bit rate
combination [NEX#19]
Specified transceiver type has invalid clock/bit rate combination.
Make sure your hardware clock rate and transceiver preferences
are correct.
20
Device's input clock is below minimum allowed for channel
[NEX#20]
Device's input clock is below the minimum allowed for the desired
channel. Choose a different transceiver or a faster clock rate.
21 Unable to compute device's comm parameters [NEX#21]
Unable to compute device's communication parameters. Verify
device clock speed and transceiver preferences. Contact
LonSupport if problem persists.
22 Out of memory while creating file '<file>' [NEX#22]
Out of memory when creating an output file. See error message for
failure details.
