Design Wash LED Pro™
©Elation Professional, Los Angeles Ca. 27 www.ElationLighting.com
each available selection.
! Reset All: This function will reset all internal motors to the home position.
! Reset Pan and Tilt: This function will only reset the pan and tilt motors to the home
position.
8.6 Effect Adjust:
8.6.1 Test Channel – This menu function allows the user to select each individual
fixture channel and test it’s function independently from the control board.
8.6.2 Manual Control –This function will center the pan and tilt motors and at the same
time bring all LEDs to 100%. The pan and tilt function will still operate if the fixture
needs to be positioned to a flat clear surface.
8.6.3 Calibrate values – This function should only be performed by a technician
familiar with the operations of fixtures of this type. This function allows a user to
make small adjustments to the motor alignment to compensate for wear or a
sensor slightly out of place. Because improper use of this function can result in
undesired operation this function has been password protected. The password is
050 and must be entered each time the calibration menu function is entered.
Because calibration is an extremely delicate procedure instruction on performing
this action are left out of this manual. For a first time calibrator, please contact our
customer support team for step-by-step instructions.
8.7 User Mode Set:
8.7.1 User Mode - This function allows the DMX channels assignment to be changed
from the default value of 13, to either 8bit/11 channels or extended mode at 13
channels. This function also allows the user to create user defined channel orders
allowing the fixture to match the channel order of other fixtures on the market for
easier operation. A total of three user modes may be configured: User Mode A,
User Mode B, and User Mode C:
