24
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
• The dishwasher must be installed on a firm floor
and adjusted to ensure that it is stable and level.
• To compensate for unevenness in the floor and to
match the height of the appliance to that of sur-
rounding units extend the threaded feet by
unscrewing. Depending on the design of the
threaded feet use either
– an open-end spanner
or
– a screwdriver.
• For built-in, integrated and fully integrated dish-
washers, the rear feet should be adjusted from the
front of the appliance using a screwdriver.
• The drain hose, inlet hose and mains cable must
not be kinked or crushed when the dishwasher is
in position.
• The dishwasher must also be screwed on tightly to
the work surface or to the adjoining units. This is
essential to ensure the diswasher does not tip.
