A SERVICE OF

logo

EVO2 MOTORIZED TREADMILL
Visit us at: www.evofitness.com
10
ASSEMBLY
STEP 1:
Remove your treadmill from the carton and place it on the floor in an open area as shown in FIG-1.
Remove the pre-assembled M6 x 55mm Bolt (33) and 6 x 13mm Washer (34) from lower upright. Make sure to connect the
wires from the Left Upright (26) to the Base Frame (43). Then insert the Left and Right Uprights (26 and 27) into the Base
Frame (43) and secure with two M6 x 55mm Bolts (33), 6 x 13mm Washers (34) and four M8 x 15mm Allen Head Bolts (35).
35
34
33
35
34
33
27
26
FIG-1
CONNECT
WIRES