A SERVICE OF

logo

i
PA 300 Peaking Amplifi er • Table of Contents
Table of Contents
68-1108-01 A
07 06
All trademarks mentioned in this manual are the properties of their respective owners.
Chapter One • Introduction ................................................... 1-1
About this Manual .................................................................... 1-2
About the PA 300 ....................................................................... 1-2
Features ........................................................................................ 1-2
Chapter Two • Installation and Operation ................. 2-1
Installation Overview ............................................................... 2-2
Mounting the PA 300 ............................................................... 2-2
Tabletop use ........................................................................... 2-3
Rack mounting ....................................................................... 2-3
Under-desk mounting ............................................................ 2-4
Through-desk mounting ........................................................ 2-5
Front Panel Features ................................................................. 2-6
Rear Panel Features ................................................................... 2-6
Cabling .......................................................................................... 2-7
Chapter Three • Adjusting the Display .......................... 3-1
Signal Compatibility ................................................................. 3-2
Potentiometer Adjustments ................................................... 3-2
Adjusting the gain with an oscilloscope .............................. 3-2
Adjusting the gain without an oscilloscope ........................ 3-2
Adjusting the peaking .......................................................... 3-3
Appendix A • Specifi cations, Part Numbers, and
Accessories .........................................................................................A-1
Specifi cations ..............................................................................A-2
Parts ...............................................................................................A-4