A SERVICE OF

logo

RCP 2000 • Operation
Operation, cont’d
RCP 2000 Remote Control Panel
4
Chapter Four
Remote Control
Manual IP Setup
Network IP Setup and Control
Network Switcher Control
3-12
Mode 3 — Pressing and holding the Reset button until the front
panel LCD display shows “Reset Mode 3” (10 seconds),
then immediately pressing the button momentarily (for
less than one second) causes an absolute system reset to
factory defaults. The LCD screen displays “Unit reset”
when the Mode 3 reset is complete.
Nothing happens if the second, momentary press does
not occur within one second.
RESET
MODE 3