A SERVICE OF

logo

Open as PDF
next previous
BASIC SHREDDING OPERATION
Continuous operation:
25-minutemaximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
25-minuteswilltrigger
40-minutecooldownperiod.
Press ( ) ON to
activate (blue)
PAPER OR CD/CARD
Feed paper straight into
paper entry and release
Plug in and put
disconnect power
switch in ON (I) position
When finished
shredding set
to OFF (
)
18
18
18
4
3
5
21
21
6
or
ToshredCDsorcredit
cards rotate safety flap
into place
Holdcard/CDatedge.
Feed into center of
entry and release
LIMITED PRODUCT WARRANTY
LimitedWarranty:Fellowes,Inc.(“Fellowes”)warrantsthepartsofthemachinetobefreeof
defectsinmaterialandworkmanshipandprovidesserviceandsupportfor2yearsfromthedate
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be
freefromdefectsinmaterialandworkmanshipforthelifetimeoftheshredder.Ifanypartis
foundtobedefectiveduringthewarrantyperiod,yoursoleandexclusiveremedywillberepair
orreplacement,atFellowes’optionandexpense,ofthedefectivepart.Thiswarrantydoesnot
applyincasesofabuse,mishandling,failuretocomplywithproductusagestandards,shredder
operationusinganimproperpowersupply(otherthanlistedonthelabel),orunauthorized
repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by
Fellowes to provide parts or services outside of the country where the shredder is initially sold
byanauthorizedreseller.ANYIMPLIEDWARRANTY,INCLUDINGTHATOFMERCHANTABILITYOR
FITNESSFORAPARTICULARPURPOSE,ISHEREBYLIMITEDINDURATIONTOTHEAPPROPRIATE
WARRANTYPERIODSETFORTHABOVE.InnoeventshallFellowesbeliableforanyconsequential
orincidentaldamagesattributabletothisproduct.Thiswarrantygivesyouspecificlegalrights.
Theduration,terms,andconditionsofthiswarrantyarevalidworldwide,exceptwheredifferent
limitations,restrictions,orconditionsmayberequiredbylocallaw.Formoredetailsortoobtain
serviceunderthiswarranty,pleasecontactusoryourdealer.
PRODUCT MAINTENANCE
TROUBLESHOOTING
CLEANING AUTO-START INFRARED SENSORS
Paperdetectionsensorsaredesignedformaintenancefreeoperation.However,onrareoccasionsthesensorsmaybecomeblockedbypaperdustcausingthemotortorunevenifthereis
no paper present.
(Note:twopaperdetectionsensorsarelocatedinthecenterofthepaperentry).
TO CLEAN THE SENSORS
1
Turnoffandunplug
shredder
LocateAuto-start
infared sensor
Dip cotton swab in
rubbing alcohol
Usingcottonswab,wipe
away any contamination
from the paper sensors
17
43
18
2
A. Overheat Indicator: WhentheOverheatIndicatorisilluminated,theshredderhasexceededitsmaximum
operatingtemperatureandneedstocooldown.Thisindicatorwillremainilluminatedandtheshredderwill
not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
B. Bin Open:Theshredderwillnotrunifthebinisopen.
Whenilluminated,closethebintoresumeshredding.
C. Bin Full:Whenilluminated,theshredderwastebinisfullandneedstobeemptied.
UseFelloweswastebag36053.
D. Remove Paper:Whenilluminated,pressreverse(
) and remove paper.
Reducepaperquantitytoanacceptableamountandrefeedintopaperentry.
A B C D