BASIC SHREDDING OPERATION
Feed paper/card
straight into paper
entry and release
When finished
shredding, set to Off
Press Auto-On ( )
PAPER/CARD
Plug in and put
disconnect power switch
in ON (I) position
Continuous operation:
Up to 5-minute maximum
NOTE: Shredder runs briefly after each pass to
clear entry. Continuous operation beyond 5-minutes
will trigger 20-minute cool down period.
HD-10C
s
2 3
4
1
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry).
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Turn off and unplug
shredder
Locate Auto-start
infrared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
3
2 4
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switch in order to perform steps above.
Once the jam is cleared, reset the SafeSense
®
feature. (See SafeSense
®
instructions below.)
SafeSense
®
paper jam: If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user
to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense
®
feature and clear the paper. Warning – when switch is in override position, the SafeSense
®
light will flash and
the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
HD-10C
s
TROUBLESHOOTING
Alternate slowly back and forthPress and hold
Reverse (R)
2-3 seconds
Set to Off (O)
and unplug
Gently pull uncut
paper from paper
entry. Plug in
1
4 5
3
Shredder doesn’t start:
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
2
PAPER JAM
HD-10C
s
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Press and hold Reverse
(R) 2-3 seconds
* Apply oil
across entry
2
3
Set to Off
1 1
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
10
Touch test area
1
Sensor lights up
3
2
Press Auto-On ( )
SET-UP AND TESTING
Press Auto-On ( )
and resume shredding
6
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
