![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/3/21/32139319-8bd4-4d3c-90c6-5f5c3c0ae10d/32139319-8bd4-4d3c-90c6-5f5c3c0ae10d-bge.png)
14
TABLE 2
Model Heater kW Power Cord Kit Voltage Amperage Receptacle
Electrical Wiring for 265 Volt
Models
NOTE:
WARNING
Electrical Shock Hazard
Turn off electrical power before service
or installation.
ALL electrical connections and wiring
MUST be installed by a qualified
electrician and conform to the National
Code and all local codes which have
jurisdiction.
Failure to do so can result in property
damage, personal injury and/or death.
Power Cord Installation
To install the line voltage power leads and conduit
to chassis, follow the instructions below and refer
to Figures 25-27 on page 19. PXCJA Conduit Kit
is required with this setup.
1.
2.