A SERVICE OF

logo

Open as PDF
next previous
9
GB
fig.fig.
fig.
Electrical connections
DANGER
Danger of electric shock! All fittings must be
installed by a competent person in accordance
with current wiring regulations and local
building regulations. If in doubt, consult a
qualified electrician.
IMPORTANT
Always switch off the electricity supply at
the mains during installation, cleaning and
maintenance. We recommend that the fuse is
withdrawn or circuit breaker switched off at the
distribution board while work is in progress.
Step 5:
• Loosenthe2shortscrewsfromthejunctionbox
(g.
).
fig.fig.
• Connect the incoming positive, neutral and
ground cables to the respective terminals. The
ground cable is already pre-assembled onto the
junctionboxtoprovidegrounding(g. ).
fig.
L (live) = Black
(ground) = Green
N (neutral) = White
L
N
• Mount the junction box onto the range hood
using2shortscrews(15)(g.
).
fig.
Step 6:
• Inserttheupperchimney(3)intothelowerchimney
(3)fromtoptobottom(g. ).
• Mountupperandlowerchimney(3)ontherange
hood (1). Fit the tab, which is bend by 90 degrees,
into the lower bracket notch and mount to the lower
bracket(5)(g. / ).
• Pulltheupperchimney(3)totheupwardpositionto
match the screw hole of the upper bracket. Mount to
theupperbracket(4)with2sidescrews(12)(g. ).
fig.
fig.
fig.
fig.
fig.
fig.
• Insert2screws(10or14)inthetoplocation,but
donotfullyinsertthescrews(g. ). Mount the
range hood (1) to the wall and tighten the screws.
Insert and tighten the 2 remaining screws on the
bottomlocationoftherangehood(g. / ).
• Attachthecollar(6)totherangehood(1).Secure
with2shortscrews(12)(g. ).
Step 3:
• Mounttheglasscover(2)ontotherangehood
(1). Use the allen key (13) to secure with 4 sets of
bolts,rubberwashers,andwashers(9)(g.
).
Step 4:
• Mount upper and lower brackets (4, 5) on the
wall. Secure with the remaining 4 sets of long
screws (10). The notches of the lower bracket
shouldbefacinguptowardstheceiling(g.
)
.
• Attachtheexhaustduct(g.
)
.
Installing the hood
Installing the hood
00-Elux FHWC3060LSA-Range hood-Book-01.indd 9 12/8/10 12:43 PM